Page 1 of 1
Peach Tree, Panel Clamps
Posted: Tue Aug 25, 2015 1:38 am
by ExtraMile
I am loving these!
What is under all of this apparatus?
Another 3-D cross. This cross, will be donated to a new and budding church
Blessings.
Incidentally, I was able to get two clamps with hard maple shafts (off of a local craigslist ad) for only $30... score
Re: Peach Tree, Panel Clamps
Posted: Tue Aug 25, 2015 1:10 pm
by Bruce
You got a good deal for sure. I hope you didn't use your MV table for assembly. I wouldn't enjoy cleaning up glue squeeze out.
Re: Peach Tree, Panel Clamps
Posted: Tue Aug 25, 2015 5:53 pm
by charlese
Yes - Good Score - The cause was just!!!!
Re: Peach Tree, Panel Clamps
Posted: Tue Aug 25, 2015 9:05 pm
by JPG
Are the cauls(shaft) curved slightly(fatter in the middle)?
Re: Peach Tree, Panel Clamps
Posted: Tue Aug 25, 2015 9:34 pm
by ExtraMile
Bruce wrote:You got a good deal for sure. I hope you didn't use your MV table for assembly. I wouldn't enjoy cleaning up glue squeeze out.
Yes, but I had a layer of wax paper directly under the glued surfaces.
Re: Peach Tree, Panel Clamps
Posted: Tue Aug 25, 2015 9:38 pm
by ExtraMile
JPG wrote:Are the cauls(shaft) curved slightly(fatter in the middle)?
Yes they have a very slight taper.
The horizontal bar of the cross isn't a full 48 inches, so I added a piece of scrap at both ends, so I could use the clamp
