Table Saw Up and Running
Moderator: admin
-
ERLover
- Platinum Member
- Posts: 3914
- Joined: Mon Aug 31, 2015 10:19 pm
- Location: Greenie and Goldie Country not to metion the WI Badgers!
Table Saw Up and Running
Well in an other thread here, I had a used TS that I just bought, kinda half died, one cracked/chipped brush. So I put in the new ones this a m, and nothing, well I installed a Safety Paddle Switch that the saw plugs into and installed that last week. So checked the brush install again, and nothing. Then the Light came on, the saw switch down stream was in the off position, Da. Fired up just fine after I turned that switch to on. $20 fix.
KNOWLEDGE AND EXPERIENCE EQUALS WISDOM. Albert Einstein
The Greatness officially starts
Greenie, Grayling, SS stand alone BS and BS SPT, jointer and belt sander, 3 Ers with Speed Changers. I think those 3 cover my ER needs, and space for them.
The Greatness officially starts
Greenie, Grayling, SS stand alone BS and BS SPT, jointer and belt sander, 3 Ers with Speed Changers. I think those 3 cover my ER needs, and space for them.