I have over two sets (1/8" to 1") of Blacksmith (post drill) drill bits for my Blacksmith (post drill) drill. The drill bits are 1/2" dia. D shank.
I like using the drill, but it is slooow, but it drills great.
Yes I do have standard drill bits, foster bits and brad point drill bits, too.
I was think about getting a 1/2" router chuck, so that I can use the drill bits on my SS.
Will the drill bits be off center? They should not be.
Has anybody done it?
What do you think?
Blacksmith drill bits
Moderator: admin