Blacksmith drill bits
Posted: Tue May 31, 2016 10:35 pm
I have over two sets (1/8" to 1") of Blacksmith (post drill) drill bits for my Blacksmith (post drill) drill. The drill bits are 1/2" dia. D shank.
I like using the drill, but it is slooow, but it drills great.
Yes I do have standard drill bits, foster bits and brad point drill bits, too.
I was think about getting a 1/2" router chuck, so that I can use the drill bits on my SS.
Will the drill bits be off center? They should not be.
Has anybody done it?
What do you think?
I like using the drill, but it is slooow, but it drills great.
Yes I do have standard drill bits, foster bits and brad point drill bits, too.
I was think about getting a 1/2" router chuck, so that I can use the drill bits on my SS.
Will the drill bits be off center? They should not be.
Has anybody done it?
What do you think?