Page 1 of 1
Will it work?
Posted: Thu Jun 09, 2016 12:54 am
by lilgodwin
Will this work on the Mark V?
It looks like it uses the standard spindle. So would it be as simple as removing the pulley and attaching an accessory knob?
Re: Will it work?
Posted: Thu Jun 09, 2016 1:05 am
by JPG
Yep and Yep!
Shaft should also protrude from the back side. Can be mounted/used on either end of the SS.
Re: Will it work?
Posted: Thu Jun 09, 2016 2:11 am
by lilgodwin
Sweet, thanks! Been looking for a good deal on one of these. We'll see how this goes.
Re: Will it work?
Posted: Tue Jun 21, 2016 12:47 am
by everettdavis
As JPG said, Yes....
What you see is one set up for a standalone tool with a motor beneath.
Everett
- beltsander on stand.jpg (35.04 KiB) Viewed 4306 times