Shopsmith Forums

Just wondering if any of you have made any finger joint projects? If so do you have any pictures I could see. Looking for a site that has more than just drawers.
Thanks!!

MERRY CHRISTMAS TO ALL!!

Here is a remote control organizer I made a year ago or so. I have a few others, I will try to find some pictures

http://www.shopsmith.com/ss_forum/viewt ... nt#p206091

And here is a thread on my learning some technique from the guys here ....

http://www.shopsmith.com/ss_forum/begin ... 17079.html

keep the projects pictures and ideas coming Thank you

Here is a thread I started when I made my first box with the Incra I-Box jig.

http://www.shopsmith.com/ss_forum/gener ... 18465.html

This is a box I made back in the mid 1970's to hold my hand faceting equipment. It was stored for many years in an unheated shed and I see some of the glue joints have started to fail.

It is made of thin plywood that I salvaged from a tea chest. The box joints were all hand cut, I laid them out by eye, (I don't think any two corners have the same number of fingers). I made the cuts perpendicular to the edge with a jewelers saw and then freed the waste tabs with a chisel.