Shopsmith Forums

Posted: **Mon May 29, 2017 11:29 am**

Its not really a lot different, I just used Krylon Crystal Clear Acrylic Flat instead of a satin finish. I think I like the Krylon Crystal Clear Acrylic satin finish better. However, The flat does look fine and works well.

The other car is here: http://www.shopsmith.com/ss_forum/viewt ... 38#p234538

: 20170522-142012 Wooden Toy Car - Hot Rod Freaky Ford - 32 Sedan - MDF - Green - Amber Shellac.resized.jpg (529.25 KiB) Viewed 6340 times

Posted: **Mon May 29, 2017 4:32 pm**

The Ford v-8 would have been in that car.
It had three exhaust ports. The center two
cylinders were siamesed into one.

Posted: **Mon May 29, 2017 5:55 pm**

oldc6 wrote:The Ford v-8 would have been in that car.
It had three exhaust ports. The center two
cylinders were siamesed into one.

Cool. Then the designer had it right. The only ones I've seen were at car shows and hot rod magazines. They had modern engines in them.

I'll bet I'm not alone.

Shopsmith Forums

Wooden Toy Car, Hot Rod 1932 Ford Sedan V2

Wooden Toy Car, Hot Rod 1932 Ford Sedan V2

Re: Wooden Toy Car, Hot Rod 1932 Ford Sedan V2

Re: Wooden Toy Car, Hot Rod 1932 Ford Sedan V2