lathe turning

[Hobbyman2]

Decided to pay around and this is what came out .

20170827_230817.jpg (259.4 KiB) Viewed 8023 times

20170827_230839.jpg (254.45 KiB) Viewed 8023 times

20170827_230854.jpg (348.08 KiB) Viewed 8023 times

20170829_114230.jpg (237.6 KiB) Viewed 8023 times

20170829_114333.jpg (285.77 KiB) Viewed 8023 times

20170829_121756.jpg (334.34 KiB) Viewed 8023 times

[BuckeyeDennis]

Very cool!

[Dansmith]

Like it. Turning is lots of fun!

[Hobbyman2]

Thanks ,, I started out with the idea of a honey pot , was going to turn the dipper on the bottom and the pot on top , the ring was going to be the lid ,,,,then better half said stop she wanted it like it is, she wants a bigger honey pot , said that was too little,,

[Hobbyman2]

20170903_082016.jpg (166.15 KiB) Viewed 7846 times

20170903_082047.jpg (126.53 KiB) Viewed 7846 times

Finished one

[Dansmith]

Sweet (pun intended). Excellent work.

[bgam65]

I have done the same and turning stuff is one of the things that make this country great as far as I'm concerned. Good Job!