Shopsmith Forums

Posted: **Sat Jul 18, 2020 4:13 pm**

One of the small things included in my recent purchase was this dust fitting, which looks as though it might be intended for the bandsaw:

: Dust fitting; 20200718_145948.jpg (19.6 KiB) Viewed 2667 times

If so, I don't have any instructions or other hardware for it and I'm not really sure where or how to mount it. There are no obvious locations and a hole would need to be cut somewhere. I do want to have dust collection on this machine; can someone provide information as to how I should proceed?

Posted: **Sat Jul 18, 2020 4:18 pm**

That is the dust collector fitting for the jointer. None of the SPT's came originally with dust collector fittings.

Posted: **Sat Jul 18, 2020 4:25 pm**

jsburger wrote:That is the dust collector fitting for the jointer. None of the SPT's came originally with dust collector fittings.

Ah, OK. I did buy a jointer (eBay); looks like some of its pieces have gotten mixed up. Thank you.

Shopsmith Forums

Installing a dust fitting?

Installing a dust fitting?

Re: Installing a dust fitting?

Re: Installing a dust fitting?