Page 1 of 1
Why do it this way?
Posted: Mon Jul 12, 2021 3:36 pm
by db5
I recently viewed on "Chip's Wood Shop" a video on using a shopsmith to tap threads. Great idea. But why, unless I already had it, do I need an adapter for a SS router bit when I already have one of these? And so do you. No set up required.
Re: Why do it this way?
Posted: Mon Jul 12, 2021 3:52 pm
by edma194
Sanding disk works fine also. Just remember that you left it up there.
Re: Why do it this way?
Posted: Mon Jul 12, 2021 4:17 pm
by roy_okc
I second a sanding disk. That's what I used when I threaded a bunch of 80/20 aluminum extrusion used in building my first CNC.
Re: Why do it this way?
Posted: Mon Jul 12, 2021 4:19 pm
by JPG
Nix on the crescent wrench(if it slips it may mar the shaft).
Sanding disk will work fine BTDT.
Leaving wrench is worse than leaving the chuck key attached!!!!
Re: Why do it this way?
Posted: Mon Jul 12, 2021 7:35 pm
by BuckeyeDennis
And then there’s my “hillbilly tapping drive”.
- E3B4B492-BF6C-4A67-9EC8-7D124326A6A5.jpeg (183.02 KiB) Viewed 1357 times
viewtopic.php?p=256309#p256309
Re: Why do it this way?
Posted: Tue Jul 13, 2021 3:20 pm
by db5
Well then, no more bright ideas for you! Unless (until) I get another one. Spanner is out, Disk is in.
Re: Why do it this way?
Posted: Tue Jul 13, 2021 3:27 pm
by reible