Page 1 of 1
Mark V Drive System Problem
Posted: Fri Dec 12, 2008 11:47 pm
by gef45
I am having problems with the quadrant and loop on the drive system. The Mark V was purchased in 1982. I haven't use it very much, it is practically new. I just began to use it again resently, and the quadrant and loop broke. I am wanting a diagram or blow-up of the drive system so as to be able to repair. Would anyone know where I might get a blowup? I was looking on the Shopsmith site for my Mark V with the Serial # 112937 which I purchased on 2/3/1982. I could not find anything with these #'s. Why can't I find anything?
All help appreciated. One lost woodworker. lol...
Posted: Sat Dec 13, 2008 12:56 am
by a1gutterman
gef45 wrote:I am having problems with the quadrant and loop on the drive system. The Mark V was purchased in 1982. I haven't use it very much, it is practically new. I just began to use it again resently, and the quadrant and loop broke. I am wanting a diagram or blow-up of the drive system so as to be able to repair. Would anyone know where I might get a blowup? I was looking on the Shopsmith site for my Mark V with the Serial # 112937 which I purchased on 2/3/1982. I could not find anything with these #'s. Why can't I find anything?
All help appreciated. One lost woodworker. lol...
Hi gef45,
You probably have this thread in the wrong forum]
http://www.shopsmith.com/ownersite/part ... dparts.htm[/URL]
Good luck.
BTW;
to these forums. If my answer did knot help you, ask again.
Posted: Sat Dec 13, 2008 1:28 pm
by charlese
Here's your blow up - -
http://www.shopsmith.com/ownersite/part ... xpview.htm
As for how old it is - Serial No. looks like January or Feb. 1982. Is it a model 500?
http://www.shopsmith.com/ownersite/faq/markv.htm
As Tim said, you should re-post under the maintenance section of the forum. You'll probably get a lot more help.
Quadrant etc.
Posted: Sat Dec 20, 2008 7:17 pm
by JPG
See your other thread about this same problem.
