Shopsmith Forums

am having problems with the quadrant and loop on the drive system. The Mark V was purchased in 1982. I haven't use it very much, it is practically new. I just began to use it again resently, and the quadrant and loop broke. I am wanting a diagram or blow-up of the drive system so as to be able to repair. Would anyone know where I might get a blowup? I was looking on the Shopsmith site for my Mark V with the Serial # 112937 which I purchased on 2/3/1982. I could not find anything with these #'s.

All help appreciated. One lost woodworker. lol...

Did you happen to check the results of your past post?

https://forum.shopsmith.com/viewtopic.php?t=2642

Did any of that help?

Ed

So, What is broke??? see attached pix.

http://www.shopsmith.net/forums/attachm ... 1229818221


PIX HAS BEEN REMOVED. JPG

I had posted to the wrong forum. Was just posting to the right one. lol...