Page 1 of 1
510 with delayed speed change after control input
Posted: Tue Mar 01, 2022 8:31 am
by timsch
I looked at a 510 from around 1980 the other day. It was "cold" when the seller started it up. When he turned the handle to change the speed, it didn't react right away. He said the belts needed to warm up 1st. Sure enough, a few seconds later the speed did begin to change.
What issues can cause this problem?
Re: 510 with delayed speed change after control input
Posted: Tue Mar 01, 2022 10:29 am
by br549
More likely that the
FLOATING sheave needs lubrication.
A similar question was posted recently:
viewtopic.php?t=28174
Re: 510 with delayed speed change after control input
Posted: Tue Mar 01, 2022 10:46 am
by DLB
timsch wrote: Tue Mar 01, 2022 8:31 am
I looked at a 510 from around 1980 the other day...
Just a word of caution. 510's came out around 1985. Nothing wrong with an older machine retrofit to a 510, but for example it may or may not have a two bearing quill (1984) which generally would be in a machine manufactured as a 510. Nothing is for sure with quills except checking, as the one and two bearing quills are interchangeable on Poly-V machines.
- David
Re: 510 with delayed speed change after control input
Posted: Tue Mar 01, 2022 12:41 pm
by timsch
BR, I'm surprised that the dial could turn without the sheave moving. I didn't think the teeth would allow that.
Thanks DLB. I needed to know that.
Re: 510 with delayed speed change after control input
Posted: Tue Mar 01, 2022 12:49 pm
by JPG
The knob/dial moves the control sheave. That alters the tension of the motor belt. The floating sheave on the motor shaft responds to that change in tension and restores the tension thus changing the speed of the quill shaft.
BTW the indicator ring only reacts to knob rotation - NOT controlled by anything that directly controls speed.