Adj. Stop Collar

Create a review for a woodworking tool that you are familiar with (Shopsmith brand or Non-Shopsmith) or just post your opinion on a specific tool. Head to head comparisons welcome too.

Moderator: admin

Post Reply
clementfeme
Gold Member
Posts: 26
Joined: Fri Mar 27, 2009 11:04 pm
Location: Longview, TX

Adj. Stop Collar

Post by clementfeme »

After seing Nick Engler show the fine vertical adjustment for the table of the Shop Smith, I dont think that I can work without one. I dod notice that Nick was using it on a 510, or a 520. I was wondering if it would also fit the tubes of my 500. Any info. would be greatly appreciated.

Clement
Top
User avatar
dusty
Platinum Member
Posts: 21530
Joined: Wed Nov 22, 2006 6:52 am
Location: Tucson (Wildcat Country), Arizona

Post by dusty »

clementfeme wrote:After seing Nick Engler show the fine vertical adjustment for the table of the Shop Smith, I dont think that I can work without one. I dod notice that Nick was using it on a 510, or a 520. I was wondering if it would also fit the tubes of my 500. Any info. would be greatly appreciated.

Clement
Yes, it will work on the 500.

Welcome to the forum. It is good to have you as a member.
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Top
User avatar
cincinnati
Platinum Member
Posts: 1172
Joined: Sun Apr 15, 2007 6:40 pm
Location: Cincinnati, Ohio

Post by cincinnati »

Good luck on getting one. Have had one on back order for some time now. I even forget when I ordered it and how much it cost.
Top
Post Reply

Return to “Woodworking Tool Review”