Page 1 of 1
Adj. Stop Collar
Posted: Sun Apr 19, 2009 7:44 pm
by clementfeme
After seing Nick Engler show the fine vertical adjustment for the table of the Shop Smith, I dont think that I can work without one. I dod notice that Nick was using it on a 510, or a 520. I was wondering if it would also fit the tubes of my 500. Any info. would be greatly appreciated.
Clement
Posted: Sun Apr 19, 2009 7:56 pm
by dusty
clementfeme wrote:After seing Nick Engler show the fine vertical adjustment for the table of the Shop Smith, I dont think that I can work without one. I dod notice that Nick was using it on a 510, or a 520. I was wondering if it would also fit the tubes of my 500. Any info. would be greatly appreciated.
Clement
Yes, it will work on the 500.
Welcome to the forum. It is good to have you as a member.
Posted: Sun Apr 19, 2009 8:03 pm
by cincinnati
Good luck on getting one. Have had one on back order for some time now. I even forget when I ordered it and how much it cost.