Page 1 of 1
520 main table rails and aux table rails don't align
Posted: Thu May 09, 2024 10:10 am
by flackbait
Hello Everybody,
I purchased a SS 500 to 520 upgrade package. The tube guides in the extruded rails on the new main table do not align by a significant amount with the tube guide in the extruded rails on the new aux table. I used the spacer that came with the kit. I'm off by by more than the adjustment slots in the aux table will allow. I also noticed that the aux table mounting tubes leave more of an over hang on one side. Is this the in-feed side or the out-feed side or does it make a difference? The instructions seem straight forward, but but vague. Maybe i am missing something. Pictures to follow.
Re: 520 main table rails and aux table rails don't align
Posted: Thu May 09, 2024 1:32 pm
by chapmanruss
Posting pictures of the problem you are having will be helpful. If I understand your problem correctly, just like the Model 500 original tables there is a greater distance from the front of the table to the mounting on the Extension Table Base. There is a difference between the front Fence Rail Extrusions and the rear ones. The Fence Rail Extrusions mount to the tables with the same thickness spacer front and back. The 520 Extension Table mounts differently to the Extension Table Base than it does for the Model 500. See the picture below.
_
- Extension Table Mounting.jpg (91.92 KiB) Viewed 10399 times
.
Notice the nuts above and below the Mounting Base which allows for easier aligning to the Main Table. Model 500 Extension Tables needed to be shimmed between the Mounting Base and the Table casting for alignment.
I have an Extension Table that is warped and therefore will not align. Hopefully this is not the cause of your difficulty aligning the Extension Table.
Floating Tables are the same as the Extension Table without the threaded studs installed. Hopefully you received the Special Set-Up and Alignment Gauge used for installing the Fence Rails to the Tables. The PDF below shows using the Setup Gauge on the first page figure A-1.
https://shopsmith.com/wp-content/upload ... 8-FREE.pdf
Re: 520 main table rails and aux table rails don't align
Posted: Thu May 09, 2024 2:04 pm
by HopefulSSer
chapmanruss wrote: ↑Thu May 09, 2024 1:32 pm
Notice the nuts above and below the Mounting Base which allows for easier aligning to the Main Table. Model 500 Extension Tables needed to be shimmed between the Mounting Base and the Table casting for alignment.
As an aside (and not that this helps the OP), on a 500 you can remove the bolts and install long-ish studs and nuts as are on the 510/520, then the adjustment no longer requires shims.