circuit breaker that I don't know about. Did I damage the motor?
Phil
motor not starting
Moderator: admin
motor not starting
machine running fine, than I left the switch in the on position for several weeks without the start button pushed. now will not start, Is there a fuse or
circuit breaker that I don't know about. Did I damage the motor?
Phil
circuit breaker that I don't know about. Did I damage the motor?
Phil
-
JPG
- Platinum Member
- Posts: 35598
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: motor not starting
Power Pro?
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: motor not starting
If yes to Power Pro, is it a Gen 1 or Gen 2 version? The Gen 2 has both a fuse and a thermal disconnect, either of which could give you this symptom. (Though neither of which should in this case, I think.) Mine is Gen 1. I often leave the power switch on and the machine not running for weeks at a time.
- David
- David