Page 1 of 1
part size info needed please
Posted: Wed Jun 17, 2009 11:56 am
by myxpykalix
I need to know some basic deminsions for the shopsmith power coupler.
What is the inside diameter of the metal coupler? What is the outside diameter? Length of coupler? thanks
Posted: Wed Jun 17, 2009 2:27 pm
by dusty
The plastic coupler is 5" long.
The ID of the plastic coupler ends is 1.122"inches and 1.123".
The OD of both metal hubs is 1.122".
The ID of the two metal hubs is .623".
Hope this answers all your questions.
Posted: Wed Jun 17, 2009 2:42 pm
by JPG
dusty wrote:
...
The ID of the two metal hubs is .623".
...
The shaft the metal hubs fit onto are 5/8" and 1/2". The headstock end is always 5/8" The 1/2" coupler connects to the jointer and I think the scroll saw and the old jigsaw. All other SPT's are 5/8".