Push Block ques.

groundsman · Post by **groundsman** » Sat Dec 19, 2009 4:51 pm

I'm new to the fourm, have had my Mark V since 91(new). I have a small shop so it fits well and does what I want it to do, in fact I have always said the wife will go before my Shopsmith, any way the rubber on my push blocks is wore out, I have a new mouse pad to cut up and install, my question is what kind of glue should I use? And which side of the mouse pad goes against the plastic? Thanks in advance. Dave

cocacola1012 · Post by **cocacola1012** » Sat Dec 19, 2009 5:56 pm

You've had your SS since '91 and just posted. What took you so long?? Just kidding. Welcome to the forum.
Check out this link.
http://www.shopsmith.net/forums/showthr ... =mouse+pad

Gene Howe · Post by **Gene Howe** » Sat Dec 19, 2009 5:57 pm

3M 77 spray adhesive would work. As would regular contact cement. The side the mouse slid on would be the side to glue.