Page 1 of 1
Casters
Posted: Tue Jan 26, 2010 10:13 pm
by sliver
I’m in the process of rebuilding my 1954 Greenie and I needed new casters. The originals are those awful steel things and they’re rusty and very unfriendly to my concrete basement floor. So I went to one of my favourite places to shop, Princess Auto and found these. (Yup, I’m in Canada). I usually only buy stuff on sale but I splurged and paid the full retail price of $4.99 each. I know, decadence can only lead to self destruction but hey, they’re thermoplastic and they just plug right in where the original casters were. They’re the same 3/8” stem, 2” wheel, and they’re rated for 80lbs each. The stock number is 8039901. Just thought you’d like to know if you need casters too. Happy ShopSmithing.
Posted: Wed Jan 27, 2010 9:11 am
by ungawa
I what to the pics of them installed, not just the caster. Thanks
Posted: Wed Jan 27, 2010 9:51 am
by sliver
I don't have them installed yet, but they're the same size as the originals, at least on my old Greenie. Welcome to the forum.
Posted: Wed Jan 27, 2010 11:19 am
by jayhawk
Does the 1954 Greenie use the same casters as what is listed on Shopsmith's 17 Most Ordered Parts page? I ordered a set a few weeks ago and got them within a week. They were $3.99 each.
Posted: Wed Jan 27, 2010 11:50 am
by pennview
I have a few bad casters as well, but I've been planning to just replace the wheels since I had a few spare casters that I picked up from Harbor Freight on sale for $.99 each. The diameter of the wheels is a good match for the originals. However, the hole through the wheel is about 6mm and I haven't found a suitable substitute for an axle yet so the project is in limbo for a while. Next time at Home Depot I'll look for some nails/spikes that might do the job.
Posted: Wed Jan 27, 2010 1:57 pm
by sliver
pennview wrote:I have a few bad casters as well, but I've been planning to just replace the wheels since I had a few spare casters that I picked up from Harbor Freight on sale for $.99 each. The diameter of the wheels is a good match for the originals. However, the hole through the wheel is about 6mm and I haven't found a suitable substitute for an axle yet so the project is in limbo for a while. Next time at Home Depot I'll look for some nails/spikes that might do the job.
That's what I was originally going to do with mine but I coudn't find the wheels any cheaper than the Princess Auto casters. 6mm is just a touch under 1/4" so try a bolt that size to see how it fits. You might have to shim the axle a bit to get a good fit but they just might work.