headstock assembly View
Moderator: admin
headstock assembly View
the view on shopsmith page is not in detail enough are there any other pictures out there.. i'm working on the speed control.
Send me an Email (annbill.mayo@comcast.net) for pictures and information. I replace the quadrant roll pin with a 10-32 allen head bolt 2 1/2" long with star washers and a nylock nut to prevent the one leg from bending and destroying the quadrant teeth.rfr58 wrote:the view on shopsmith page is not in detail enough are there any other pictures out there.. i'm working on the speed control.
Bill Mayo bill.mayo@verizon.net
Shopsmith owner since 73. Sell, repair and rebuild Shopsmith, Total Shop & Wood Master headstocks, SPTs, attachments, accessories and parts. US Navy 1955-1975 (FTCS/E-8)
Shopsmith owner since 73. Sell, repair and rebuild Shopsmith, Total Shop & Wood Master headstocks, SPTs, attachments, accessories and parts. US Navy 1955-1975 (FTCS/E-8)
rfr58 wrote:the view on shopsmith page is not in detail enough are there any other pictures out there.. i'm working on the speed control.
Does this help? Look at page 6B of this PDF. 150% magnification helps! http://www.shopsmith.com/ownersite/productmanuals/MKVSTDPartsList%20_1_14.pdf
Part names and numbers for the speed control are on page B7,
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Chuck in Lancaster, CA
view of speed control
yes it is bigger printcharlese wrote:Does this help? Look at page 6B of this PDF. 150% magnification helps! http://www.shopsmith.com/ownersite/productmanuals/MKVSTDPartsList%20_1_14.pdf
Part names and numbers for the speed control are on page B7,