Shopsmith Forums

the view on shopsmith page is not in detail enough are there any other pictures out there.. i'm working on the speed control.

rfr58 wrote:the view on shopsmith page is not in detail enough are there any other pictures out there.. i'm working on the speed control.

Send me an Email (annbill.mayo@comcast.net) for pictures and information. I replace the quadrant roll pin with a 10-32 allen head bolt 2 1/2" long with star washers and a nylock nut to prevent the one leg from bending and destroying the quadrant teeth.

rfr58 wrote:the view on shopsmith page is not in detail enough are there any other pictures out there.. i'm working on the speed control.

Does this help? Look at page 6B of this PDF. 150% magnification helps! http://www.shopsmith.com/ownersite/productmanuals/MKVSTDPartsList%20_1_14.pdf

Part names and numbers for the speed control are on page B7,

charlese wrote:Does this help? Look at page 6B of this PDF. 150% magnification helps! http://www.shopsmith.com/ownersite/productmanuals/MKVSTDPartsList%20_1_14.pdf

Part names and numbers for the speed control are on page B7,

yes it is bigger print