Page 1 of 1
OPR Parts
Posted: Thu Jul 14, 2011 10:50 pm
by wgander
Will someone please post a photo of the Spacer Block (Ref part 83, 515513) and 1/4", 1/2" and 3/8" Pins (ref parts 46,47,48, 515499,515500,515502)? I don't know what these parts look like.
I haven't used my Routing System (555413) overarm and under table, with router table upgrade for years.
Posted: Fri Jul 15, 2011 12:07 am
by reible
Requested photo
[ATTACH]13703[/ATTACH]
Ed
Thanks
Posted: Fri Jul 15, 2011 6:58 pm
by wgander
Thank you.
The pins are probably in a box with all of my router bits. I don't remember seeing anything like the spacer; I'll have to look again and probably order one. Without it, the overarm holder, safety shield and dust collector aren't very secure.
Posted: Fri Jul 15, 2011 8:07 pm
by reible
Hi,
If you want I can add some dimensions and you can just make one out of wood. It is not a critical sized piece and they may not carry it anymore anyway.
Ed
dimensions
Posted: Sat Jul 16, 2011 8:26 pm
by wgander
Ed, thanks: please post or email (
wgander1@comcast.net) the dimensions for me.
Bill
Posted: Sat Jul 16, 2011 9:42 pm
by reible
Hi,
Looks like maybe some 1/2" plywood/MDF for the bottom part then glue on a 1/4" part of like material and spray black should do it.
[ATTACH]13738[/ATTACH]
Ed
Thanks
Posted: Sat Jul 16, 2011 10:26 pm
by wgander
Thank you...
Posted: Sun Jul 17, 2011 11:59 am
by peterm
Ed
Nice job of marking the photo with dimensions and arrows............what program did you use, please?
Posted: Sun Jul 17, 2011 5:34 pm
by reible
Thanks.
The program is Micrografx Designer which is no longer around, sadly.
Ed
prmindartmouth wrote:Ed
Nice job of marking the photo with dimensions and arrows............what program did you use, please?
Posted: Sun Jul 17, 2011 7:51 pm
by peterm
Thanks ED. I did some Googling, found that program is now part of a "suite" sold by Corel and seems to cost $999............guess I will continue to use Excel.
