Safety miter on 10er

chipmaster · Post by **chipmaster** » Fri Dec 02, 2011 10:41 pm

I see these safety miters for sale for the Mark V--Will they fit the 10ER? Can I swap parts and make them fit? Are they as cool to work with as they look in the demos?

v/r,

Rick

heathicus · Post by **heathicus** » Sat Dec 03, 2011 10:14 pm

Once upon a time, Shopsmith sold a miter bar that would fit the 10ER table and would accept the Mark V's miter gauge and safety grip. The safety grip will not fit on the standard 10ER miter bar. Not without some modification anyway.

skou · Post by **skou** » Sat Dec 03, 2011 10:44 pm

Rick, Skip, the owner of the Yahoo ER group makes the miter bar, just like SS used to sell, so you can use the MkV/5 safety miter on your ER.

In fact, you should probably join that group.

steve

chipmaster · Post by **chipmaster** » Mon Dec 05, 2011 2:01 pm

skou wrote:Rick, Skip, the owner of the Yahoo ER group makes the miter bar, just like SS used to sell, so you can use the MkV/5 safety miter on your ER.

In fact, you should probably join that group.

steve

Thanks Steve--I'm in that group also. I don't use it as well as I should. This forum format is what I'm most familiar with, but I will try to modify my habits.

v/r,

Rick

kschwarz20 · Post by **kschwarz20** » Mon Dec 12, 2011 3:01 pm

I bought one of the bars from Skip for my ER. It works great.

heathicus · Post by **heathicus** » Mon Dec 12, 2011 4:51 pm

Thanks for the update.