Art of a conical-point screw mating with an offset hole
Posted: Wed Feb 29, 2012 10:35 am
Here's something interesting. There's probably been hundreds of Shopsmith owners who tighten their machine in drill-press mode and notice that the Arm Lock Knob (part # 2) isn't dead-center over the "dimple" in the Base Arm (part #24). Then the folks on the forum explain the exact benefits of that design.
Here is a blog mentioning a similar technique on a high-end handplane:
http://www.daedtoolworks.com/blog/
(See the Feb 21 2012 entry.)
Cool stuff! BTW I am expecting to receive a nice new block plane any day now. I'll keep the type secret until I get it.
Here is a blog mentioning a similar technique on a high-end handplane:
http://www.daedtoolworks.com/blog/
(See the Feb 21 2012 entry.)
Cool stuff! BTW I am expecting to receive a nice new block plane any day now. I'll keep the type secret until I get it.