Shopsmith Forums

Hi Clyde, Here's the link to my posting on using Brasso and a Weiler, coarse nylon cup brush attached to my 3/8" drill to clean up my sander. https://forum.shopsmith.com/viewtopic.php?t=4635&page=3 It's working great now. Edit added: Mike reminded me to be sure and wear a respirator or at ...

Thanks for the link I looked for it but did not fine it, must of not looked hard enough.

Clyde

I have this model 640 Magna 6'' belt sander that I am repairing and looking for a parts diagram that shoes how it goes together and how to adjust it. I have all the parts to it, but need it to put it back together. also needs welding done to it, one side is broken in two places. Also what is a good ...

You have acquired a Mark V model 500! The 'missing' part(s) are the second and fourth from the left in the post below. https://forum.shopsmith.com/viewtopic.php?p=34403&postcount=1 I looked into getting the round crank handle but shop smith said it would inter-fear with other parts of the table...

Here is some pictures of my Mark V. And one with the made up part that I was missing for the table crank handle.

Clyde

If the bracket is cast steel it can be welded. Take a magnet and see if it will stick to it if so then you can weld it. I would grind the broken joint on both pieces and preheat them to 250 -350 degrees then weld it with a nickel wire like 81 nickel wire then but it in a oven at 350 degrees for an h...

I am new to the site and wanted to share my short story on a fix. I always wanted a shop smith and was talking to a friend about things and the subject came up about wood working and I told him that i would like to get a shop smith some day. Well he said he had one that was given to him and he was d...