Shopsmith Forums

I am using a Dell venue 11 pro with win 8.1.

The problem is that it is smarter than I am!

Thanks
Geo

Talk about light milling...

Got the new toys set up and dialed in. alignment is off by a few thousandths, but I am not going to lose sleep over it.

The piece that is in the vise is one I did before buying the xy table and the vise... So that's why it looks a little wiggly.

I figure with the new ...

Hi all. I'm away from my 510 right now and could use some help.

Would someone please send me the outer measurements of the table?
And the measurement from the left side of the table to the left side of each miter slot?

Thanks!
Geo

Hi Guys

After reading your responses I decided to pull the trigger

I ordered the 5.5" x 12" compound slide table and the improved 4" vise. Oh, and the t-slot nuts to bolt the vise to the table.

To mount it on the 510 I plan on using a sheet of 3/4 plywood. Mounting the base of the table to that ...

thanks JPG. I really want to have the ability to have x-y travel...for accurate hole placement.

I also want to mill a slot .293 wide x .750 long in .125 aluminum...
I don't need incredible accuracy for this, but better than holding on by hand.

I have the SS vise, but it is almost next to useless ...

Hi All

After a long break, I have returned to the SS forums. Looks like the admin did some cleaning up of accounts, because mine was gone and I had to start a new one... First world problem.

I would like to use my 510 to do some very light milling and am thinking of adding a cross slide vise or X ...