Search found 3 matches
- Fri Jul 10, 2015 7:48 am
- Forum: Maintenance and Repair
- Topic: Bandsaw Upper Bearing Part Number
- Replies: 12
- Views: 7119
Re: Bandsaw Upper Bearing Part Number
I did drill and tap a hole for a zerk grease fitting on this one before installing the needle bearings but decided that was not really needed again as I saw no real wear occurring on the dozens of arm shafts of the bandsaws I serviced. Removal of the upper bandsaw wheel to allow the use of a pipe on...
- Fri Jul 10, 2015 7:48 am
- Forum: Woodworking Tool Review
- Topic: Re: Corner Clamps
- Replies: 22
- Views: 17935
Re: Corner Clamps
There is a bit of difference from the SS/HF clamp and yours. The newer version has an "X" opening rather than just a right angle. This "X" allows more options to clamp.Visit our Website for more info.
- Fri Jul 10, 2015 7:47 am
- Forum: General Woodworking
- Topic: Today in the shop (I don't know what to call it??)
- Replies: 15
- Views: 7253
Re: Today in the shop (I don't know what to call it??)
I was thinking that I could make use of this for other then drilling operations but so far that is about as far as I've gotten on that thinking. I do have a tray in red that I have mounted on a board in the same way. Visit our Website for more details .