Shopsmith Forums

Trying to interpret this sentence in the "Dado Set operating instructions" from SS. For grooves 1/4" wide , use both outside cutters set face to face. --- Note that the ground portion of the crosscutting teeth on the cutters are placed side by side and that the ground portions face th...

I wont give guidance, but I will tell you what worked for me..hopefully something useful can be gleaned from it for your application. I have a Jet 650CFM unit with about 10-12 feet of 4" flex tube terminating on the tool with a 3 or 4 inch long , 2.5" diameter hose for quick disconnect/rec...

Man its been one of those weeks. Compressor died in upstairs AC unit-family has been camping in the downstairs for a week now. Dead battery in wifes' car-not clear why this happened yet :) Suspect it may never be clear. This morning- waking up to this : swearing.jpg I've tried to make the manufactur...

I didn't read it all-so forgive if it has already been said.
Last line of defense is a good dustmask or respirator.

I think I have #3 on the list..fairly comfortable.

https://www.edcmag.com/best-dust-masks-for-woodworking/


b

I put in 3, 20A circuits to be on the safe side and for potential "new" tools. 1. SS is on its own 110/20A (didnt want to go the 220 route). I think the powerpro manual says the unit can pull 13-14A...so I err'd on the safe side. 2. Jet Dust Collector on its own 110/20A . Although the curr...

Is there a list somewhere that says when and where the demo's will occur?

thank you

Is the table absolutely true to the blade?

If I press on my main table when its is only 2 post supported, it does have some movement if it is not supported by the
auxiliary table/legs. Is it possible the main table has some movement rather than the blade?


b

A well deserved gift of appreciation.

Lets hope your generous nature rubs off on a few more citizens !

Sincerely hope the guy who went missing is OK..but given the details with him leaving all his equipment etc, it doesnt sound like that part of the story is going to end well.

The gentle taper really adds elegance !

The stained parts are plywood (3/4" maybe) , the legs/frame are ripped down 2x4 pine. All hand sanded to 180 grit i think. Leftover pieces I had in the pile. I screwed up in assembling it ahead of stain/paint..which became a bear chasing stain and white paint around the various pieces-but its m...