Any suggestions for how to get this stuff off? I soaked it in evapo-rust because it was so covered in rust I couldn't see the adhesive underneath. Worked great on the other side but on the face this film is pretty tough and I think there may be a backing layer.
Also, I know there are options for how to adhere the sanding disk (velcro?), what do people think is the best way to go?
Thanks
cleaning old sanding disk?
Moderators: HopefulSSer, admin
cleaning old sanding disk?
- Attachments
-
- Screen Shot 2021-04-30 at 1.18.25 PM.png (2.49 MiB) Viewed 603 times
Re: cleaning old sanding disk?
Might want to check these past threads out:
viewtopic.php?p=271947#p271947
viewtopic.php?p=272294#p272294
viewtopic.php?p=270195#p270195
viewtopic.php?p=265768#p265768
viewtopic.php?p=271947#p271947
viewtopic.php?p=272294#p272294
viewtopic.php?p=270195#p270195
viewtopic.php?p=265768#p265768
RF Guy
Mark V 520 (Bought New '98) | 4" jointer | 6" beltsander | 12" planer | bandsaw | router table | speed reducer | univ. tool rest
Porter Cable 12" Compound Miter Saw | Rikon 8" Low Speed Bench Grinder w/CBN wheels | Jessem Clear-Cut TS™ Stock Guides
Festool (Emerald): DF 500 Q | RO 150 FEQ | OF 1400 EQ | TS 55 REQ | CT 26 E
DC3300 | Shopvac w/ClearVue CV06 Mini Cyclone | JDS AirTech 2000 | Sundstrom PAPR | Dylos DC1100 Pro particulate monitor
Mark V 520 (Bought New '98) | 4" jointer | 6" beltsander | 12" planer | bandsaw | router table | speed reducer | univ. tool rest
Porter Cable 12" Compound Miter Saw | Rikon 8" Low Speed Bench Grinder w/CBN wheels | Jessem Clear-Cut TS™ Stock Guides
Festool (Emerald): DF 500 Q | RO 150 FEQ | OF 1400 EQ | TS 55 REQ | CT 26 E
DC3300 | Shopvac w/ClearVue CV06 Mini Cyclone | JDS AirTech 2000 | Sundstrom PAPR | Dylos DC1100 Pro particulate monitor