Light Duty Plug for Mk 5/V Tubes

allsas · Post by **allsas** » Wed Oct 19, 2011 5:24 pm

I can't think of any good coming from packed sawdust in the Bench and Way Tubes that had accumulated in the current rehab project. It was packed too hard to be cleared by shop vac and seemed like a clog of 4 - 6" length. Fortunately, this MK 5 was in a dry garage.

I thought that a one gallon milk bottle cap would fit in the tube. No joy. By cutting slits in the side of the bottle cap, it would fit.

# slits ----- Reward
4 ----- Rest of milk, in bottle, no beer
3 ----- 2 oz beer
2 ----- 4 oz beer, quit for the day.
1 ----- TBD
0 ----- Scraped knuckles, pinched fingers, all beer in the garage

Only suggestion is to avoid cutting into the top, cut slit in the side of the bottle cap only. [ATTACH]14516[/ATTACH]
Bottle Cap w/ one of three slits.
[ATTACH]14517[/ATTACH]
Inserted Bottle Cap. Tube was set on floor to seat it evenly.

Caps used are marked "PORTOLA 358-CP05-68" , inside the cap.

judaspre1982 · Post by **judaspre1982** » Wed Oct 19, 2011 5:42 pm

===============================

JPG · Post by **JPG** » Wed Oct 19, 2011 6:56 pm

I like that! Now if there were not 3 different sized tubes!

robinson46176 · Post by **robinson46176** » Wed Oct 19, 2011 8:24 pm

Sawdust in the tube is not something I worry about much but if I were I would likely grab a can of high expansion foam insulation and just fill them. Heck it might even make the machine quieter.

.

JPG · Post by **JPG** » Wed Oct 19, 2011 8:26 pm

robinson46176 wrote:Sawdust in the tube is not something I worry about much but if I were I would likely grab a can of high expansion foam insulation and just fill them. Heck it might even make the machine quieter.

.

I like that better(one size fits all!);)

judaspre1982 · Post by **judaspre1982** » Wed Oct 19, 2011 8:58 pm

=============================

damagi · Post by **damagi** » Thu Oct 20, 2011 10:09 am

Just upgrade to a double tilt setup...then you no-longer have to worry about it.