Thanks Bill. Did you use anything like formica to cover the top surface? Was the quarter inch ply thick enough?wa2crk wrote:Brick
I make my own ZCI's using 1/4" plywood and the slot is cut by raising the blade through the insert. The slot is extended using the router table and a
1/4" bit as seen in the photo. This permits the use of the riving knife and upper saw guide.
Bill V
you solved the thing i noticed with the blade guard/riving knife being a little offset from the saw blade. At least it is unless i tighten the saw blade right up against the lower cover.......
Dusty, thanks for the help. I'll do some more reading and then begin to begin!!
thanks, bill