Small roll pin

mrhart · Post by **mrhart** » Sat Oct 06, 2012 4:05 pm

There is a small roll pin in my parts box as I'm putting things back together. Its hard to see it on the diagram, I'm trying to remember where it goes. I remmeber there was some mistake on a thread a while back of someone thinking it was an allen head screw. I remember it just taps out...

JPG · Post by **JPG** » Sat Oct 06, 2012 4:42 pm

mrhart wrote:There is a small roll pin in my parts box as I'm putting things back together. Its hard to see it on the diagram, I'm trying to remember where it goes. I remmeber there was some mistake on a thread a while back of someone thinking it was an allen head screw. I remember it just taps out...

Some dimensions might help. OD, length.

mrhart · Post by **mrhart** » Sat Oct 06, 2012 4:46 pm

1 inch long, maybe 1/8 diameter.

dusty · Post by **dusty** » Sat Oct 06, 2012 5:18 pm

mrhart wrote:There is a small roll pin in my parts box as I'm putting things back together. Its hard to see it on the diagram, I'm trying to remember where it goes. I remmeber there was some mistake on a thread a while back of someone thinking it was an allen head screw. I remember it just taps out...

What have you taken apart?

Table Height Control Handle maybe? No. That one is not 1" long.

SDSSmith · Post by **SDSSmith** » Sat Oct 06, 2012 5:57 pm

How about the pin that goes in the shaft that holds the base arm in the base (right side of the frame)? If you had more than one, I would suggest looking at your casters.

JPG · Post by **JPG** » Sat Oct 06, 2012 6:42 pm

SDSSmith wrote:How about the pin that goes in the shaft that holds the base arm in the base (right side of the frame)? If you had more than one, I would suggest looking at your casters.

Ditto!!!!!!!!!

mrhart · Post by **mrhart** » Sat Oct 06, 2012 9:02 pm

I think its the pin that goes through the threaded rod and handle on the carrage lock.
There has been gremlins on my work bench.

JPG · Post by **JPG** » Sat Oct 06, 2012 10:18 pm

mrhart wrote:I think its the pin that goes through the threaded rod and handle on the carrage lock.
There has been gremlins on my work bench.

That one would be smaller (< 1").