Stand Mount Scrollsaw

dusty · Post by **dusty** » Tue Oct 23, 2012 9:41 am

And here are the rest.

[ATTACH]18888[/ATTACH]

[ATTACH]18889[/ATTACH]

[ATTACH]18890[/ATTACH]

[ATTACH]18891[/ATTACH]

pennview · Post by **pennview** » Tue Oct 23, 2012 10:11 am

While on the subject of scrollsaws, can someone tell me the exact measurement for the distance between the two saw blade clamps on the Shopsmith scrollsaw. I have an older scrollsaw that doesn't have those built-in templates on the side of the table for establishing the proper length of blade between the two clamps.

SDSSmith · Post by **SDSSmith** » Tue Oct 23, 2012 11:44 am

pennview wrote:While on the subject of scrollsaws, can someone tell me the exact measurement for the distance between the two saw blade clamps on the Shopsmith scrollsaw. I have an older scrollsaw that doesn't have those built-in templates on the side of the table for establishing the proper length of blade between the two clamps.

4-3/8"............

BigSky · Post by **BigSky** » Tue Oct 23, 2012 11:46 am

pennview wrote:While on the subject of scrollsaws, can someone tell me the exact measurement for the distance between the two saw blade clamps on the Shopsmith scrollsaw. I have an older scrollsaw that doesn't have those built-in templates on the side of the table for establishing the proper length of blade between the two clamps.

The exposed blade between the two brackets is 4 11/16" on mine but that is not a critical dimension. The tension control will compensate for some deviation.

pennview · Post by **pennview** » Tue Oct 23, 2012 1:17 pm

Thanks guys! I'm planning to build a jig that will mimic the template on the Shopsmith table so that the blades can be swapped out quickly.

mrhart · Post by **mrhart** » Fri Oct 26, 2012 6:21 pm

Dusty, yours looks the same as the Master Inside exploded view pic of a Mark V Mount version. I see yours is a stand mount though.
Look at the pic of mine, its different??

[ATTACH]18910[/ATTACH]

SDSSmith · Post by **SDSSmith** » Fri Oct 26, 2012 7:54 pm

mrhart wrote:Dusty, yours looks the same as the Master Inside exploded view pic of a Mark V Mount version. I see yours is a stand mount though.
Look at the pic of mine, its different??

[ATTACH]18910[/ATTACH]

I believe your is just lacking the blade block upgrade that is in place on Dusty's machine.

mrhart · Post by **mrhart** » Fri Oct 26, 2012 11:20 pm

Thanks for the link. For those of you who have this upgrade, is it a worthy cause?

dusty · Post by **dusty** » Sat Oct 27, 2012 5:43 am

mrhart wrote:Thanks for the link. For those of you who have this upgrade, is it a worthy cause?

Absolutely. Be aware, this upgrade only effects blade change; making easier and less time consuming. Everything else is the same.

The cutouts in the table top are no longer needed if you have the upgrade.

mrhart · Post by **mrhart** » Sat Oct 27, 2012 11:28 am

Dusty on the back of your last pic (rear cradle) there is a black cyliner for hold down or support maybe. Even with the Master Inside Mark V scroll saw exploded view (page 58) on 400% view, I don't see it.