Conduit yet another project/test

[reible]

So this is my latest conduit project. It is a project and a test at the same time.

The concept is to make a sliding pegboard piece that will ride along in front of a shelf system thus allowing access to the shelf about half at a time.

The frame of the pegboard is made out of 1/2" conduit. Using self tapping sheet metal screws though holes in the pegboard then into the conduit.

[ATTACH]22018[/ATTACH]

The pegboard is used to locate the placement of the sheet metal screws.

[ATTACH]22019[/ATTACH]

The backside

[ATTACH]22020[/ATTACH]

The hanger bit is a 3/4" piece of conduit, the top holes are getting a screw driver into to tighten the screws shown in the next picture.

[ATTACH]22021[/ATTACH]

[ATTACH]22022[/ATTACH]

More to come.

Ed

[reible]

The rod will be another piece of 1/2" conduit. I'm thinking a coat of wax or some thin lube will let things slide easy enough because the intended load will not be excessive. Time will tell on this.

[ATTACH]22023[/ATTACH]

[ATTACH]22024[/ATTACH]

[ATTACH]22025[/ATTACH]

I don't have the shelf yet so I can not mount or test it. The bottom will ride against a board to keep the pegboard vertical. So that is about all I can show you at the moment.

Ed

[joshh]

I see you have gone conduit crazy


I really like the design and will probably steal it, very resourceful!

[jere]

Cool! I love using conduit for new things