Any good ideas for an extension table that can connect to my table? I Google and saw many ideas for a stand but I'd like a table to connect like I have seen on the other newer saws. I thought I could use the bolts underneath but those apparently are for the drill press stops.
Ideas/pics would be greatly appreciated.
Shopsmith 500 outfeed?
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35457
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Which '500' table? There are small variations from the Mark 5 to the 500.ibskot wrote:Any good ideas for an extension table that can connect to my table? I Google and saw many ideas for a stand but I'd like a table to connect like I have seen on the other newer saws. I thought I could use the bolts underneath but those apparently are for the drill press stops.
Ideas/pics would be greatly appreciated.
My goldie has tapped holes in large bosses in the miter slots near the back edge. What I believe is a more 'modern' vintage has small bosses in that area. Another of unknown vintage has no bosses there. It came with a greenie trunion attached, but only has the single slot.
In any event the back edge does not lend itself well due to the rip fence clamping to that edge.
I think any 'attaching' need be done from the bottom(sides???) with clearance for the rear rip fence clamp.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
500 outfeed
[ATTACH]26161[/ATTACH][ATTACH]26159[/ATTACH] Here is what I did. it worked well for me , hope it will help[ATTACH]26160[/ATTACH].[ATTACH]26158[/ATTACH] I didn't post this very good but I hope it gives you the idea. 
- Attachments
-
- josh 050.JPG (176.13 KiB) Viewed 5746 times
-
- josh 055.JPG (161.9 KiB) Viewed 5742 times
-
- Untitled.png (8.51 KiB) Viewed 5742 times
-
- Untitled2.png (349.3 KiB) Viewed 5743 times