Iron table bandsaw -- label for cover

JPG · Post by **JPG** » Sat Jan 31, 2015 9:14 pm

paulrussell wrote:Yes. I debated with myself over painting the guard, but finally decided it gave a nicer look. YMMV.

Makes sense to do so. As was the insert.

Keepa u pinkies away from the red area!

paulrussell · Post by **paulrussell** » Wed Feb 11, 2015 3:08 pm

Bearings came today, and I did the 15 minute alignment sequence to get all the bearings aligned properly. It only took me 90 minutes!

Did a few test cuts for the first time with PowerPro, and all was well.

Still to do is align the table 90 degree stop, and the miter slots to the blade.

Next on my list is refurbing the belt sander.

paulrussell · Post by **paulrussell** » Wed Feb 11, 2015 8:43 pm

So I discovered, as expected, that my tension window quickly "fogs up" with sawdust inside the cover. However, I was able to verify my suspicion that a quick blast of compressed air in the Allen wrench hole cleared the window completely.

algale · Post by **algale** » Wed Feb 11, 2015 9:27 pm

I wonder if a wipe with an anti-static dryer sheet might keep the sawdust from building up on the window.

paulrussell · Post by **paulrussell** » Wed Feb 11, 2015 9:29 pm

Good idea.

Shopsmith Forums

Iron table bandsaw -- label for cover

Re: Iron table bandsaw -- label for cover

Re: Iron table bandsaw -- label for cover

Re: Iron table bandsaw -- label for cover

Re: Iron table bandsaw -- label for cover

Re: Iron table bandsaw -- label for cover