) I had a V-8 Moment! Mount the table upside down in the SPT mount! It worked perfectly and saved the table for if I ever need it again! 
Bandsaw Mount on a 10ER
Moderator: admin
-
ChrisNeilan
- Platinum Member
- Posts: 1463
- Joined: Sun Oct 27, 2013 5:30 pm
- Location: Waterford, Connecticut
- Contact:
Bandsaw Mount on a 10ER
I'm in the process of refurbishing a Bandsaw (from 1992) to reside on my 10ER. I have the SPT mount from MKC Tools (a great piece by the way)and was looking to buy a set of longer tubes to mount the saw when I looked over at my unused Mark V extension table. Just as I was about to cut the tubes off their mount ( ) I had a V-8 Moment! Mount the table upside down in the SPT mount! It worked perfectly and saved the table for if I ever need it again!
) I had a V-8 Moment! Mount the table upside down in the SPT mount! It worked perfectly and saved the table for if I ever need it again! - Attachments
-
- Bandsaw 1.jpg (36.33 KiB) Viewed 2089 times
-
- Bandsaw 3.jpg (33.11 KiB) Viewed 2089 times
-
- Bandsaw 4.jpg (40.26 KiB) Viewed 2088 times