- 025.JPG (127.04 KiB) Viewed 1406 times
10er small jointer cutterhead..must be missing something
Moderator: admin
10er small jointer cutterhead..must be missing something
On the 10er I have these 3 pieces in the photo. The arbor I thought would fit the little jointer cutter head but its not long enough or thick enough. What am I missing here. I looked at the old 10er catalog and this seems to be the right part but no...
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: 10er small jointer cutterhead..must be missing something
The cutter will mount directly on the quill shaft.
If you insist on using an arbor, a 5/8" long enough one is required.
If you insist on using an arbor, a 5/8" long enough one is required.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: 10er small jointer cutterhead..must be missing something
Duh, your right! Now that I look closer at the intructions I see it is directly mounted to the quill shaft...My bad. Thanks!