The next project begins

masonsailor2 · Post by **masonsailor2** » Fri Jun 26, 2015 8:10 pm

So the next project begins. It will involve making 10 or 15 cubes ( 10 will be made first with an option of five more) which will be 16”X 16” square and 12” deep. They will be ¾ inch thick alder panels with ¾ X ¾ inch pieces of Honduran mahogany in each corner at the end of the panels. These cubes will be stacked upon a base approx. 6 inches high to allow for leveling. The unit will be a display case that will be next to the stairs and step down to follow the stairs in a 4-3-2-1 configuration. Now for the fun part. Each cube will have a mahogany light valence at the front of the cube on all four sides to hide the led lighting strips which will have a recessed groove to accept and hide the light strip at a 45 degree angle. Each cube will require four separate dimmable controls to allow for light adjustment of each side of every cube individually. There can be no exposed wiring whatsoever. My plan is to build in a drawer in the base unit which will house all the dimmers. I will begin a sample cube this week and post pictures.
Paul

rjent · Post by **rjent** » Fri Jun 26, 2015 9:21 pm

Looking forward to seeing that brother, sounds beautiful.

What I want to know is where you get your wood ..... :/

masonsailor2 · Post by **masonsailor2** » Fri Jun 26, 2015 9:41 pm

Most of my wood is from either Austin Hardwoods in Santa Ana Ca or Jackal Enterprises in Watsonville Ca
Paul

Ed in Tampa · Post by **Ed in Tampa** » Sat Jun 27, 2015 11:01 am

masonsailor2 wrote:Most of my wood is from either Austin Hardwoods in Santa Ana Ca or Jackal Enterprises in Watsonville Ca
Paul

I did not know that Austin Hardwoods were still in business. We had one here in Tampa but it closed down. I loved to buy wood there. Little pricey but they made sure you got the best wood.

masonsailor2 · Post by **masonsailor2** » Sat Jul 04, 2015 1:15 am

Good day in the shop today. I got the cube prototype finished and approved by the boss. Now to build the other nine. I included pictures of the light valence which shows only the one in place. Ultimately there will be one on each side of the cube and mitered together. The body is alder with the corners and valence in Honduran mahogany.
Paul

edflorence · Post by **edflorence** » Sat Jul 04, 2015 10:06 pm

Should look very impressive when all the lights are on. The corner joinery is..? epoxy glued butt joints? dowels or biscuits?

masonsailor2 · Post by **masonsailor2** » Sun Jul 05, 2015 11:45 am

The corners are butt jointed biscuits.
Paul

ddub · Post by **ddub** » Mon Jul 06, 2015 10:36 pm

This picture just solved a problem of how to do something that I have been thinking on! Thank you!

Shopsmith Forums

The next project begins

The next project begins

Re: The next project begins

Re: The next project begins

Re: The next project begins

Re: The next project begins

Re: The next project begins

Re: The next project begins

Re: The next project begins