MarkV 500 through Mark 7 side by side table comparisons

[everettdavis]

Last night I prepared a comparison set of drawings and parts lists for the Mark 7, Mark V 520, Mark V 510, Mark V 505 and original Mark V 500 Tables for those who might like to see them side-by-side.

Shopsmith Mark 7 – Mark V 520 with Mark V 505 -510 and Original Mark V 500 Side-By-Side Table Exploded Parts Diagram

Shopsmith Mark 7 – Mark V 520 with Mark V 505 -510 and Original Mark V 500 Side-By-Side Table Exploded Parts Diagram.pdf

(992.83 KiB) Downloaded 1113 times

Shopsmith Mark 7 – Mark V 520 with Mark V 505 -510 and Original Mark V 500 Side-By-Side Parts Reference

Parts List Main Table Comparison.pdf

(207 KiB) Downloaded 1044 times

Note the common parts highlighted in blue are the same parts, common to the Mark 7, Mark V 520, Mark V 510 and Mark V 505.

Everett

[JPG]

Fantastic!!!!!!!!












Now about the 'early' 510.

[everettdavis]

Fantastic!!!!!!!!

Now about the 'early' 510.

Did you mean the Mark V 500 with two slots that was discontinued?

Shopsmith 500 Table with two slots -discontinued-.jpg (100.26 KiB) Viewed 4054 times

If there is another early 510 Table, I don't know about it. Do you have any data on it you could send me? To my knowledge I haven't seen one myself.

Everett

[JPG]

Fantastic!!!!!!!!

Now about the 'early' 510.

Did you mean the Mark V 500 with two slots that was discontinued?

Shopsmith 500 Table with two slots -disontinued-.jpg

If there is another early 510 Table, I don't know about it. Do you have any data on it you could send me? To my knowledge I haven't seen one myself.

Everett

NO, I meant the 510 with mouse holes in the rails, no kepnuts, but with torx screws.

Later I will post add/delete list.

[everettdavis]

Never saw one of those. Looking forward to learning about them.

Everett

[JPG]

...........Early...........Current.......
.......514338 (2)........514667 (2) .....TUBE
.......514440 (4)........514440 (4) .....JACKSCREW *
.......514450 (6)........................TORX SCREW **
.........................515294 (4)......KEP NUT **
.........................120392 (4)......FLAT WASHER

* Part # the same, design different.

** newer tube has studs and table has through holes in the table edge.
** older tube has holes and access holes for the screws, and tapped holes in the table edge.

[everettdavis]

Wow. Different parts, same part number. Somebody wasn't thinking when they did that.

I learn something every day it seems.

Thanks

Everett

[JPG]

Wow. Different parts, same part number. Somebody wasn't thinking when they did that.

I learn something every day it seems.

Thanks

Everett

Although the design is different, they are 'sorta' interchangeable.

The older design will work in the newer tables as originally intended for the older table.

The newer design will work in the older table as originally intended for the newer table.

The older design has a smaller 'finger grabbing surface' but has holes for the SS tool kit to use as a 'method' to dimple the connecting tubes .

The current design has a larger thumb wheel and no gorilla hole .

This not an isolated example.