Did I mention I went shopping for jig saw blade lately?
I guess I'm pretty out of touch with jig saw blades of late. OK I don't use mine all that often but still.
Yet another blade that I had not seen before. It is designed to cut on the down stoke, to do so the blade is much thicker then a normal blade. Have not gotten to use these yet but it might be interesting, or I hope so anyway.
I'm not sure if you will see the model number in the picture so it is DW3762H in case you want to read up on them or shop for them.
So has anyone tried these?
IMG_9798sc.jpg (82.09 KiB) Viewed 1598 times
Ed
{Knight of the Shopsmith} [Hero's don't wear capes, they wear dog tags]
I used the one that came in an assortment package by Bosch. Same idea. I found I had to go slower than I normally do and any SLIGHT upward or sideways pressure change by me (like getting a different grip to make a curved cut), caused the saw to jump and scar the cut. It might have been me (and probably was ), but the saw seemed to wander more than usual.
I don't have many projects where the cut laminate is exposed, but I still prefer a good couple of layers of painters tape marking the way. Then a nice file to pretty up the edge.
Methinks constant downward pressure would be required.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
), but the saw seemed to wander more than usual.
