Quill Not Returning to 0
Moderator: admin
Quill Not Returning to 0
Not sure if I am using the right terminology here but the quill that extends the arbor does not return to 0. Meaning I think it should go back a bit more. Is this photo normal? Shouldn't the guard sit flat against the headstock?
- Attachments
-
- IMG_2416.JPG (126.42 KiB) Viewed 799 times
Re: Quill Not Returning to 0
Another question might be what is missing from your shopsmith.
Ed
- IMG_0104sc.jpg (85.41 KiB) Viewed 791 times
{Knight of the Shopsmith} [Hero's don't wear capes, they wear dog tags]
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Quill Not Returning to 0
Notice yours stops closer than the rubber bumper(missing) will allow(the bumper acts as a soft stop).
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: Quill Not Returning to 0
Ah, so there is a part missing? Could one be made from rubber gasket material?
Re: Quill Not Returning to 0
I have never tried this but I think that an "O" ring with a cross section of about 1/8" and proper diameter may work until a proper replacement can be obtained.
Bill V
Bill V