I’ve always found using two wrenches each time I mount or remove a bit to be really yech! It’s especially bad when mounted in a router table without a router lift. (if you have a router lift maybe this doesn’t apply?) I have to remove the router from the table to access the chuck and get my two wrenches in place. And if you have a fence mounted it’s also problematic.
Not any more, at least not for me. The chuck tightens or loosens a bit with an approximate ¼ turn of a 5/32” allen wrench. That’s right the very same wrench we use for our SS. I use a ball end wrench which gives me ever greater flexibility. Now I can easily remove or mount a bit without removing the router from the table.
It’s worked great on every bit I’ve tried. I did have some serious vibration with this chamfer bit but I just loosened it and turned the bit about ¼ turn, re-tightened and it was fine. . It works well with reducers so you can use ¼” shank bits just as easily as ½” shank.
I got mine on Amazon but Rockler and Woodcraft have it too.
- MC 470.jpg (56.77 KiB) Viewed 8874 times
- unit mounted on router in table
- MC 469.jpg (61.97 KiB) Viewed 8874 times
- with bit
- MC 467.jpg (60.54 KiB) Viewed 8874 times
- tightening bit into chuck
- MC 468.jpg (65.49 KiB) Viewed 8874 times
- ball end T wrench 471.jpg (31.11 KiB) Viewed 8874 times
