billmayo wrote:Yes, I leave about 1" of wire from the winding connections. I solder new wires to the 1" long wires. I use shrink wrap tubing over this soldered connection....
Rewiring the motor wasn't as successful as I had hoped. I followed Bill Mayo's guidance, however the wire insulation was bad all the way to the windings. Made the best of it, hoping it'll work.
I take my hat off to you Bill, for the more than dozen that you have done...this was NOT fun!
2016-03-02 17.40.05-1.jpg (355.17 KiB) Viewed 1977 times
1955 Mark 5 SN-316919 (in pieces)
1956 Mark 5 SN-344051 (restoration in-work)
1962 Mark 5 SN-375717 (restoration in-work)
Spokane, WA
Shopsmith Mark V S/N: 354008 Born: 1958/Restored: 2015
Magna Bandsaw S/N: 31575 Born: 1956/Restored 2016
Magna Jointer S/N: 67527 Born: 1958/Restored: 2015
Spokane, WA
Shopsmith Mark V S/N: 354008 Born: 1958/Restored: 2015
Magna Bandsaw S/N: 31575 Born: 1956/Restored 2016
Magna Jointer S/N: 67527 Born: 1958/Restored: 2015
Looking really good Silenthope. Nothing like a "new" Shopsmith to work with!
Dick 1965 Mark VII S/N 407684
1951 10 ER S/N ER 44570 -- Reborn 9/16/14
1950 10 ER S/N ER 33479 Reborn July 2016
1950 10 ER S/N ER 39671
1951 jigsaw X 2
1951 !0 ER #3 in rebuild
500, Jointer, Bsaw, Bsander, Planer
2014 Mark 7 W/Lift assist - 14 4" Jointer - DC3300
And a plethora of small stuff .....
"The trouble with quotes on the Internet is that you can never know if they are genuine." - Benjamin Franklin
Replaced the quad assy (pork chop), "aligned" the ears and replaced the pin with the "Bill Mayo" bolt. Everything looked good until I installed the quad assy. The pork chop to control sheave bearing button is not centered. Is this "normal"/OK?
2016-03-07 21.05.18.jpg (68.68 KiB) Viewed 1678 times
2016-03-07 20.49.21-1.jpg (130.88 KiB) Viewed 1678 times
1955 Mark 5 SN-316919 (in pieces)
1956 Mark 5 SN-344051 (restoration in-work)
1962 Mark 5 SN-375717 (restoration in-work)
All the new ones I have seen, and those I have replaced do center properly.
The phrase that caught my attention, was 'aligned the ears' suggesting you had to entice them into position before Bill Mayo's Modification.
From the vantage point of the picture (which could be an optical distortion) they do not appear perpendicular to the base. It looks like they are twisted just a bit as well, all of which could be optical.
Do you have another known good unit to compare it to?
