Space between tubes on the main table for model 510

reubenjames · Post by **reubenjames** » Fri Mar 11, 2016 2:26 pm

Does anybody know, or is anyone near enough to measure, the space between the two rack and pinion mounting tubes on the Mark V 510 main table? The purpose of the question is in regard to under-SS storage options--I want to be able to lower the table without the storage getting in the way of the tubes. I won't be home until late tonight, so won't get a chance to measure until tomorrow afternoon.

reible · Post by **reible** » Fri Mar 11, 2016 5:14 pm

From memory I used 14" when I built an under storage unit but again from memory I think you could go just a bit wider, perhaps 14-1/4. We just got back from shopping and I have to get some lunch and then if no one has checked in with new numbers I will go out and measure to be sure.

Ed

reible · Post by **reible** » Fri Mar 11, 2016 5:44 pm

Yes you have about 14-1/4 from inside leg to inside leg. So my memory was pretty good.

Ed

reubenjames · Post by **reubenjames** » Fri Mar 11, 2016 8:24 pm

Nice. Thanks, Ed!

Shopsmith Forums

Space between tubes on the main table for model 510

Space between tubes on the main table for model 510

Re: Space between tubes on the main table for model 510

Re: Space between tubes on the main table for model 510

Re: Space between tubes on the main table for model 510