Vintage chestnut, vintage clampage

[nuhobby]

I finally got a little more time to work these old boards. The basement is showing about 12% R.Humidity this early January (lots of forced-air heat going on!). I planed them out some more times since they were curving a bit from dryness, then committed the joints layout. This will put things in place for subsequent power-routing some grooves inside the case:

Chest Joints.JPG (122.97 KiB) Viewed 6896 times

Chris

[nuhobby]

Doing a bit more with both power routing and manual rabbeting....

Fitting Chestnut Shelf.JPG (126.17 KiB) Viewed 6834 times

Chestnut Carcass Glued.JPG (111.64 KiB) Viewed 6834 times

[nuhobby]

I finally finished this little guy; it will be for a nephew with a birthday coming up. I'll probably enclose some educational material on "wormy chestnut" as well.

By the way, the chisel in the last photo is fitted with a chestnut handle from an online seller. It's really what inspired me to seek out this type of wood

Knob for Josh's chest.JPG (116.41 KiB) Viewed 6782 times

Josh's chest closed.JPG (104.55 KiB) Viewed 6782 times

Josh's chest open.JPG (94.24 KiB) Viewed 6782 times

Happy woodworking!
Chris

[algale]

Nicely done!

[rjent]

Absolutely beautiful!

I assume a magnet and plate keeps it closed?

Nicely done!

[nuhobby]

I assume a magnet and plate keeps it closed?

Thanks very much! I put a rare-earth magnet pair in the knob-hole and in a little wood horseshoe inside the case, under the top panel.
The *other* thing besides magnets to get the door to stay closed is to not tighten the hinge screws too much. Same thing I encountered in 7th grade Shop class, "competing" hinges on a lid tend to bind up and not stay shut, so it's best to only use moderate torque on their screws.