I’m painting my shopsmith 10er and I need to know how to remove the cap on the trunnion where the wrench is. Does it just pull off or something else?
Thanks
Taking apart of Trunnion on10-er
Moderator: admin
-
Fireballxl5
- Silver Member
- Posts: 15
- Joined: Wed Sep 02, 2020 7:07 pm
- Location: Thousand Oaks, Calif
-
chapmanruss
- Platinum Member
- Posts: 4543
- Joined: Tue Aug 26, 2014 8:16 pm
- Location: near Portland, Oregon
Re: Taking apart of Trunnion on10-er
The cap is has been center punched at the factory so it does not turn on the threaded shaft. For painting the table tie bar the entire assembly of the threaded shaft, wrench, cap and other parts can be removed/unscrewed from the tie bar.
Russ
Mark V completely upgraded to Mark 7
Mark V 520
All SPT's, 2 Power Stations & Crafter's Station
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored.
Mark V completely upgraded to Mark 7
Mark V 520
All SPT's, 2 Power Stations & Crafter's Station
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored.
-
Fireballxl5
- Silver Member
- Posts: 15
- Joined: Wed Sep 02, 2020 7:07 pm
- Location: Thousand Oaks, Calif
Re: Taking apart of Trunnion on10-er
Thank You Russ