Need an attaching bolt for my belt guard. Anyone know what size bolt it is. The owners manual doesn't give the size.
Thanks
Belt guard attaching bolt
Moderator: admin
-
Fireballxl5
- Silver Member
- Posts: 15
- Joined: Wed Sep 02, 2020 7:07 pm
- Location: Thousand Oaks, Calif
-
chapmanruss
- Platinum Member
- Posts: 4534
- Joined: Tue Aug 26, 2014 8:16 pm
- Location: near Portland, Oregon
Re: Belt guard attaching bolt
Two different bolts have been used for attaching the Upper Belt Guard to the Headstock. The early one was a standard hex bolt with a flat washer while the later one was a knurled socket screw that uses a 3/16" Allen Wrench. Both are 3/8"-16 x 1/2" long. The picture below is the Hex Bolt but without the flat washer.
The Picture below is the knurled socket screw.
- 102-37 Hex Hd Cap Screw.jpg (136.44 KiB) Viewed 858 times
- A 2333 Screw - Socket - Knurl - belt cover.jpg (181.25 KiB) Viewed 855 times
Russ
Mark V completely upgraded to Mark 7
Mark V 520
All SPT's, 2 Power Stations & Crafter's Station
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored.
Mark V completely upgraded to Mark 7
Mark V 520
All SPT's, 2 Power Stations & Crafter's Station
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored.