When reinstalling the PowerPro motor I noticed there are 6 locations for bolts, but I only have 4 bolts. I would like to order the remaining two bolts from Shopsmith, but do not know how to find them. They are part number 50 in the schematic included and I have a picture of one at the tip of my finger. Suggestions on their proper name so I can order? Thanks
IMG_4198.jpeg (108.47 KiB) Viewed 368 times
IMG_0274.jpeg (286.54 KiB) Viewed 368 times
520 upgraded to PP. Bought used. Primarily use as Saw and Lathe
Aaron wrote: Thu Feb 24, 2022 4:30 pm
They are part number 50 in the schematic included and I have a picture of one at the tip of my finger. Suggestions on their proper name so I can order?
Ref. No. 50 is PN 522659 described as "M6-1 X 10 SFHC Screw." This info came from a PP Upgrade manual, 556202 Rev. B, really the continuation of the drawing you attached.
Note that with the full description you can get these elsewhere if you so choose.
DLB wrote: Thu Feb 24, 2022 4:49 pm
Ref. No. 50 is PN 522659 described as "M6-1 X 10 SFHC Screw." This info came from a PP Upgrade manual, 556202 Rev. B, really the continuation of the drawing you attached.
Note that with the full description you can get these elsewhere if you so choose.
After thinking that answer over for a minute it occurred to me that there is NO WAY that those screws are only 10 mm long. So while the manual says they are "M6-1 X 10 SFHC Screw" I believe they are in fact M6-1 X 16. They are metric grade 10.9.